Dickson WiZARD2, Руководство пользователя

Страница: 11 / 33

Page | 11
5) Click on Save Changes and Start to add
6) Logger Configuration Complete window will open. Disconnect USB from Logger. Wait for the ‘Add
Logger’ window to close before connecting USB to another device.
Wireless Loggers:
•
They will begin logging and transmitting as soon as they are configured.
•
Go to page 12 for Determining Proper Logger/Repeater Placement
Ethernet Loggers:
•
Ethernet loggers will begin logging as soon as they are configured but will not begin
transmitting until they are connected to a valid Ethernet connection AND powered via AC.
•
Loss of AC power will cause the Ethernet logger to stop transmitting, however they will
continue to save data.
NOTES:
•
Keep the logger(s) at the PC until all other Repeaters and Loggers have been installed. Do not turn
loggers off.
•
Now that the software and devices have been fully installed, the application does not need to be up
and running in order for the data to be saved to the database. Just open the application and check
to make sure the Broker and Receiver are connected (look for the broker’s status in the lower left of
the WiZARD2’s software window. Close the application when viewing data is not required.
•
If the PC prompts you to reboot the PC at any time once a device is added, respond “No”.
•
Once all devices have been added, make sure loggers are communicating properly before moving.
o
This can be confirmed by looking at the ‘Logger’ tab and ensuring all loggers have a time
stamp in the ‘Last Transmission’ field.
•
When moving loggers and repeaters, do not turn them off. Allow AC units to run on battery power
while in transition.
•
Do not turn the loggers off. Turning the loggers off will cause them to loose time. All saved
data will be invalid. If a logger is turned off, Clear it via the Edit window to reset the clock.