SM-200 TE Grinding and Honing Machine
70
Servicing and Maintenance
10
No cooling water. Insufficient water in the
tank.
Refill the water and clean the
tank if necessary.
Pump is not connected. Connect the pump to the desi-
gnated socket on the machine.
Valve is closed.
Open the valve.
Water pipe is defective
or blocked.
Clean the pump filter.
Clean or replace the water-
bearing components.
Defective component.
Check the power supply and
replace the pump if necessary.
Insufficient torque
on the grinding
belt or polishing
wheel in combi-
nation with a
whistling noise.
Too little tension on the
V-ribbed belt.
Increase the tension of the V-
ribbed belt.
V-ribbed belt is worn.
Replace the V-ribbed belt.
Dirt is blocking the free
running of the discs.
Clean them so that they run
freely again.
Insufficient torque
on the grinding
wheel and grin-
ding belt or on the
polishing wheel.
Too little tension on the
V-belt.
Re-tension the V-belt.
V-belt is worn.
Replace the V-belt.
Component defect is
present.
Replace the defective compo-
nent.
Grinding belt can-
not be adjusted.
Deflection pulley is
worn.
The deflection pulley
must be bevelled.
Replace the deflection pulley.
Mechanics are sluggish
or defective.
Repair the mechanics.
Contact wheel is worn.
Replace the contact wheel.
Grinding belt can-
not be tensioned.
Mechanics are sluggish
or defective.
Repair the mechanics.
Increased and
unusual noises.
Component damage
(bearings, loose screw
connection).
Localise the source of the
noise and replace the defec-
tive component if necessary.
Play in the lifting
device.
Wear on the wedge.
Tighten the wedge.
Wear on the guidance.
Replace the assembly.
Fault
Cause
Remedy
Содержание SM-200 TE
Страница 76: ......