Dick SM-200 TE, Руководство по эксплуатации, Страница: 35 / 76

SM-200 TE Grinding and Honing Machine 35
Setting up the Machine
8
Set the position of the grinding belt on the roller on the belt adjust-
ing screw
[3] .
If the grinding belt does not run symmetrically to the contact wheel,
first make a rough adjustment to the running direction.
1 Set the switch for the abrasives to position 0 (OFF).
If the grinding belt is still running, wait until it stops.
2 Loosen the star handles [2] and remove the belt safety guard.
3 Move the grinding belt on the front roller to the desired posi-
tion. Move the grinding belt a little by hand.
4 Preset the belt run with the belt adjusting screw.
- Rotating to the left, the grinding belt moves to the left.
- Rotating to the right, the grinding belt moves to the right.
5 The grinding belt must not run against the guard or the side
panel. The SM-200 TE grinding and honing machine is then
damaged.
If the running direction of the grinding belt is roughly in the correct
position, replace the belt safety guard and fasten it with the star
handles.
6 Move the switch for the abrasives briefly to position I (ON).
7 Check the belt movement when starting up the grinding belt.
The grinding belt must not touch the side panel or belt safety
guard.
Repeat steps 2, 3 and 4 if the grinding belt does not run in the cor-
rect position.
8 If the belt run is roughly in the correct position, set the switch
for the abrasives to position
I (ON).
The abrasives start up.
9 Now make a fine adjustment to the grinding belt with the belt
adjusting screw
[3] .
- Rotating to the left, the grinding belt moves to the left.
- Rotating to the right, the grinding belt moves to the right.
10 Set the correct position.