Dick SM-200 TE, Руководство по эксплуатации, Страница: 43 / 76

SM-200 TE Grinding and Honing Machine 43
Setting up the Machine
8
8.10 Clamping the grinding plate
The guided sharpening of machine knives is performed with the
special grinding plate. The grinding plate will be produced individ-
ually by request to suit the workpiece.
The grinding plate replicates the shape of the knife edge on one
side. Fix the knife to the back of the grinding plate after using a
lever on the front to insert it into the knife-specific mountings.
First clamp and set the right grinding plate on the grinding arm for
grinding a machine knife.
1 Lower the grinding arm with the foot pedal. Position the
mounting surface of the universal mounting head almost hor-
izontally to the grinding wheel.
2 Loosen the two clamping levers of the grinding device.
3 Move the grinding device horizontally so that approximately 1
cm of the mounted grinding plate will subsequently rest on the
grinding wheel.
4 Clamp the two clamping levers of the grinding device.
5 Remove the clamping lever [1] on the universal mounting head.
6 Place the grinding plate without a workpiece on the shaft of
the universal mounting head. The other side of the grinding
plate rests on the grinding wheel.
CAUTION
Risk of injury from knives and abrasives
• Set the On/Off switch for the abrasives to position 0 (OFF) for
the preparatory adjustments.
• Do not mount or remove the grinding plate with the workpiece
attached.
Note
Use the correct grinding plate!
Sharpen the workpiece only with the appropriate grinding plate.
• If the grinding plate and workpiece do not fit together, this
may damage the workpiece, the grinding plate and the grin-
ding and honing machine.