Dibo JMB-S 200/18 I, Руководство пользователя

Страница: 67 / 95

DiBO n.v. 67
7. Malfunction table
At a possible malfunction one can consult the table mentioned below and if you obtain on this basis no solution, we
advise to contact a DiBO- technician and/or a recognized DiBO- representative.
Malfunction Cause Solution
Machine does not start
%DWWHU\LQVXI¿FLHQW
Recharge and/or replace battery
No fuel in engine Fill the tank with fuel
Key switch off Put key switch on
Rest malfunctions Consult an expert
No water pressure Few water supply Repair water supply
Filter blocked
&OHDQUHSODFH¿OWHUFDUWULGJH
Instable and to weak pressure Air in water supply (leaks in water
supply) Put machine completely without
power! Repair leaks in supply.
Nozzle or lance blocked or worn-out. Clean or replace
Pressure regulator defect Consult an expert
Rest malfunctions Consult an expert
Water in product tank
1RUHWXUQYDOYHLQ¿OWHUGHIHFW 5HSODFHVXFWLRQ¿OWHU
No additions of products Suction pipe Repair suction pipe
6XFWLRQ¿OWHUVWXIIHGXS &OHDQVXFWLRQ¿OWHU
Product tank empty
5H¿OORUUHSODFHWDQN
Spray pressure to high Lower spray pressure
No hot water Burner switch not on position “1” Put switch on position “1”
No fuel present in the tank Fill the tank, clean or replace the
IXHO¿OWHU
Temperature sensor defective Consult an expert
Rest of malfunctions Consult an expert
Aerator does not turn Fuse defect Check fuse
Burner switch not on position “1” Put burner switch on position “1”
Electrical motor defective Consult an expert
HP pump pulse Leak or congestion in supply conduit Clean/replace/repair
To much air present De-aeration of cleaner
Hot water temperature is not reached Temperature too low or working
pressure to high Higher temperature c
reduce work pressure