Diamond SmartLyte, Руководство по обслуживанию

Страница: 32 / 81

4 Description of Modules
ECO 9085 SOP05-5038F Rev.05 Effective Date: 12/06/18 Page 32 of 81
4. Description of Modules
4.1. Mechanical Assemblies
4.1.1. Front Door Assembly
The front door assembly is comprised of the following parts, Front Door,
CN-4002
, EMI
Window,
CN-4193
, Plastic Window,
CN-4092
and Door Magnets.
The front door can be removed by moving the analyzer to the edge of a work surface so
the analyzer door, when opened, will extend past the edge of the work surface. First
remove small ground connector, then ground screw, external tooth washer, right angle
tab, and hex nut. Then with one hand, hold the analyzer door near the right side hinge pin
and, with the other hand, gently apply pressure to the middle rear area of the door. This
will allow the right hinge pin to clear the retaining hole in the main chassis. The door can
then be removed from the analyzer.
The window is comprised of two layers, the EMI window and the plastic window. Both
can be replaced in the field by gently pressing from the rear of the window and snapping
the EMI and plastic window out toward the front of the door. During replacement the
EMI window should be placed over the opening first, ensuring good contact of the EMI
window adhesive with the copper tape on the frame of the window. Next the Protective
window is applied over the EMI window.
Fig. 4-1
Front Door
Plastic Window