Diamond Products CC5049D, Руководство оператора

Страница: 46 / 68

MAINTENANCE
Lubricate Front Axle Bearings
1. Raise the saw to the full up position.
2. Add no more than two pumps of grease to
each of the two front axle bearings grease
fittings located under the frame base on
both the left and right side.
Front Axle Bearing Grease Fitting
Lubricate the Optional Bogie Wheel
The bogie wheel has two locations for adding
grease. The first is on the wheel axle located
on the side of the wheel. The second location
is on the caster bracket on the back of the
wheel.
1. Add one pump of grease to both grease
fittings located on the bogie wheel.
Bogie Wheel Grease Fittings
250 Hour Service
Clean the Air Cleaner Element
WARNING
DO NOT operate the saw without the filter
installed
1. Empty the rubber dust ejector boot by
pressing inward on both sides of the ejector
boot. This will release any large particles of
dust or dirt.
2. Pull out the tab on the air cleaner housing
end cover.
End Cover Tab
3. Turn the end cover counter-clockwise to
unlock and pull the cover away from the
main air cleaner housing.
4. Pull the outer primary filter out of the air
cleaner and inspect it for damages.
Replace as necessary. To protect the
engine, DO NOT pull out the inner safety
filter.
Outer Primary Filter
46