Diamond Products CC5049D, Руководство оператора

Страница: 47 / 68

MAINTENANCE
5. Move away from the saw and clean the
filter from the inside out. Use dry
compressed air to clean the filter (a
maximum of 30 psi or 2.1 bar) and rotate it
while cleaning.
6. Inspect the inside of the air cleaner housing
and the end cover for debris, and wipe
them down with a damp cloth as
necessary. DO NOT use compressed air to
blow out the inside of the air cleaner
housing. DO NOT allow dust to enter the
air intake tube when cleaning or replacing
parts.
7. Place the filter into the air cleaner housing
(over the inner safety filter) and gently push
the filter into the unit until it feels secure.
8. Place the end cover tightly up against the
ridge at the end of the air cleaner housing.
9. Turn the end cover clockwise to lock the
cover onto the air cleaner housing, making
sure the dust ejector boot is in the vertical
position.
10. Push the tab in on the air cleaner housing
end cover to secure.
11. Press the restriction indicator reset button
on the restriction indicator after the unit has
been cleaned.
Replace Engine Oil and Filter
•
Refer to Engine Operator’s Manual for oil
and oil filter specifications and capacities.
1. Run the engine until it reaches normal
operating temperature and then shut the
engine OFF.
WARNING
DO NOT drain the oil with the engine
running.
2. Raise the saw frame and place drain pan
beneath drain hose located on the right
side of the saw just in front of the upright
assembly.
Oil Drain Hose
3. Remove the engine oil fill cap.
Engine Oil Fill Cap
4. Remove red plastic drain plug and open
drain valve on side of oil pan.
Oil Drain Valve.
5. Drain oil completely
6. Remove the oil filter located between the
engine and the upright assembly using a
filter wrench.
7. Dispose of the oil and filter in accordance
with city, state and federal regulations.
8. Shut oil drain valve and replace red plastic
drain plug.
9. Install a new filter on the engine. Lubricate
the rubber gasket on the filter with a film of
oil prior to installing it.
10. Tighten the filter only hand tight.
47