Diamond Products CC5049D, Руководство оператора

Страница: 43 / 68

MAINTENANCE
Inspect all hydraulic hoses and fittings daily for
leaks. Remember to use cardboard or a piece
of paper when checking for leaks and replace
damaged components immediately.
Check Hydraulic Fluid Level for Hydro
Pump Assembly
Prior to checking the hydraulic fluid level,
ensure that there is no blade installed on the
saw and the saw frame is in a level position.
1. Check the hydro pump reservoir tank level.
Hydro Pump Reservoir Tank
2. If the level is below the “Full Cold” line
then, remove the reservoir tank cap.
3. Add SAE 15W-40 oil to the reservoir tank
fill line. DO NOT overfill as fluid will leak out
from the reservoir cap.
4. Replace the cap and tighten to secure.
Adding Fluid to the Hydraulic Lift Pump
Hydraulic Lift Pump Breather Cap
Check the fluid daily and add fluid to the pump
as necessary.
1. Lower the saw to level the frame.
2. Unlatch and lower the rear cover screen.
3. Remove the hydraulic pump breather cap.
4. Using a funnel with flexible hose, add
SAE15W-40 oil or an equivalent to just
below where the fill port extends into the
hydraulic pump. Do not overfill, as this will
cause oil leakage through the breather cap
when raising the saw.
5. Replace the breather cap and retighten to
secure.
6. Close the rear cover screen and latch to
secure.
7. Replace the hydraulic pump fill access
plug.
Check Radiator Coolant Level
Prior to checking the radiator coolant level,
ensure that there is no blade installed on the
saw and the saw frame is in a level position.
CAUTION
Remove the radiator cap only when it feels
cool to the touch, and always open it slowly
to relieve any built up pressure.
1. Slowly remove the radiator cap located
through the radiator cap access on the top
front of the radiator shroud.
Radiator Cap Access
2. Check that the coolant level is up to the
overflow hole inside the filler neck.
3. If it is below the filler neck, add a 50/50 mix
of water and antifreeze until it reaches that
point.
4. Replace the radiator cap and retighten to
secure.
43