MAINTENANCE
Lubricate the PTO Bearings
1. Swing the cover plate on the belt guard
away enough to expose the front face of
the PTO.
2. Add three pumps of grease to the PTO
using the grease fitting located on the PTO
face.
PTO Grease Fitting
50 Hour Service
Drain the Fuel/Water Separator Filter
Inspect the fuel/water separator filter and drain
as necessary. The unit is located inside the
upright at the rear of the saw.
1. Locate the drainage cap on the underside
of the fuel/water separator.
2. Place a suitable container under the filter.
3. Loosen the cap only enough to allow water
to be discharged from drainage tube.
Do
not remove the cap.
4. When no more water is discharged, re-
tighten the drainage cap.
f
Fuel/Water Separator Filter
Drain Water from the Fuel Filter
Inspect the fuel filter and drain as necessary.
The unit is located between the upright and the
engine.
1. Locate the drainage cap on the underside
of the fuel filter.
2. Place a suitable container under the filter.
3. Loosen the cap only enough to allow water
to be discharged from drainage tube.
Do
not remove the cap.
4. When no more water is discharged, re-
tighten the drainage cap.
Fuel Filter
Lubricate the Hydraulic Cylinder Pivot
Pin
1. Ensure the saw is parallel to the ground.
2. Add one pump of grease into the hydraulic
cylinder pivot pin grease fitting located at
the back of the front axle assembly.
Pivot Pin Grease Fitting
Drainage Cap
Drainage Cap
45
Содержание CC5049D
