Diamant F60000, Инструкция по эксплуатации и перечень запасных частей

Страница: 18 / 52

18
• Mandatory
• Obligatorio • Prohibition
• Prohibición
• Indication
• Indicación • Warning Triangle
• Triángwulo De
Advertencia
These signs will give advice for your safety
Before leaving our factory every machine
is thoroughly tested.
Follow our instructions strictly and your machine
will give you long service in normal operating
conditions.
1. Features
Use: Surface grinding of concrete or other types of
flooring. For repairing horizontal surfaces that
have been damaged by the weather, or by
improper finishing methods, or that require
removal of deteriorated coatings, overlays, or
buildups.
Tools:
1) 2 x 2 x 4” (50 x 50 x 100 mm) size, Six (6) per unit.
In any of the types shown below:
a) Grinding Stones [FIG. 14]
b) Tungsten Carbide Segment Block
[FIG. 16].
c) Tungsten Carbide Impregnated Grinding
Block (Not Shown)
d) Scarifier Blocks (Star, Beam, TC wheels)
[FIG. 27 & FIG. 28].
e) Wire Brushes [FIG. 26].
f) Diamond Blocks [FIG. 15].
2) Multi-Segmented Diamond Disks: Two (2) disks per
unit, 10” (250 mm) diameter, 10 or 20 diamond
segments on each disk [FIG. 24 & FIG. 25].
3) Tool Holding Pad, with “hook-and-loop” type of tool
attachment, holds the following [FIG. 19]:
a) Scrubbing Pad [JJ] [FIG. 19]: Two (2) pads
per unit, 10” (250 mm) diameter, Nylon
mesh Impregnated with Silicon Carbide.
(For information contact your Dealer)
Depth of Cut (Maximum):
See Section 4 (Tool Installation & Application)
Maximum material Size: N/A
Nominal & Operating Weight: See “Specifications”.
Dimensions, Grinding Width, Spindle Shaft RPM:
See “Saw Dimensions”.
Before starting up machine make sure you
read these instructions and are familiar
with the operation of this machine.
The working area must be completely
clear, well lit and all safety hazards
removed (no water or dangerous objects in
the vicinity)
The operator must wear
protective clothing
appropriate to the work he
is doing.
We recommend hearing,
respiratory and eye
protection.
Any persons not involved in the work,
should leave the area.
Only work of flat horizontal areas.
Working on steep slopes or hills could
cause the operator to lose control of the
machine. This could result in injury or
death to the operator or other persons in
or near the work area!
2. Assembly
q When unpacked, this unit is fully assembled,
except for installation of the grinding “tools”. For
tool installation See Section 4 of this document.
q The dealer or end user must do the installation of
optional or accessory items, such as a water tank
kit.
3. Check Before Operating
All Models:
q Take into account the working conditions from a
health and safety point of view.
q For start up refer to the engine, or motor manual.