Dexter Laundry 20VCIS2, Руководство пользователя

Страница: 368 / 387

FR
IT
EL
PL
ES
PT
RU
UA
BR
EN
RO
KZ
FR
IT
EL
PL
ES
PT
RU
UA
RO
KZ
EN
BR
367
5. OPERATION
To make the best possible cut, follow these helpful hints:
Hold the saw firmly with both hands.
Avoid placing your hand on the workpiece while making a cut.
Support the workpiece so that the cut (kerf) is always to your side.
Support the workpiece near the cut.
Use clamps or other practical ways to secure the workpiece so that the workpiece will not move
during the cut.
Draw a guideline along the desired line of cut before beginning your cut.
CROSS CUTTING/RIP CUTTING
When making a straight cross cut or rip cut, align the line of cut with the 0° blade guide notch on
the base.
Since blade thicknesses vary, always make a trial cut in scrap material along a guideline to
determine how much, if any, you must offset the guideline to produce an accurate cut.
NOTE: The distance from the line of cut to the guideline is the amount you should offset the guide.
RIP CUTTING
Use a guide when making long or wide rip cuts with the saw.
Secure the workpiece.
Clamp a straight edge to the workpiece using C-clamps.
Saw along the straight edge to achieve a straight rip cut.
NOTE:
Do not bind the blade in the cut.
BEVEL CUTTING
Adjust the angle of the cut to any desired setting between 0 ° and 45°.
If making a 45° bevel cut, align the line of cut with the 45° blade guide notch on the base.
Make a trial cut in scrap material along a guideline to determine how much you should offset the
guideline on the cutting material.
ADJUSTING THE BEVEL SETTING
Loosen the bevel adjusting knob.
Raise the motor housing end of the saw until you reach the desired angle setting on the bevel scale.
Tighten the bevel adjusting knob securely.
WARNING: Attempting a bevel cut without having the bevel lock knob securely tightened can
result in serious injury.