DeWalt P2201, Руководство по эксплуатации

Страница: 8 / 32

P2201
Model P2201 Cat. No. DDF211022P
8
Troubleshooting
alWayS CheCk inSTRuCTion Manual FoR PRoPeR aSSeMBly oF PaRTS
PRoBleM PoSSiBle CauSe SoluTion
fastener Overdriving Power level too high / Pin too short Use a lower powder load level number or a longer pin
Soft base material Check base material suitability section
Tool does not fire Tool not depressed completely See “Tool does not depress completely” section below
firing pin damaged Replace damaged part(s)
Tool does not depress completely Damaged firing pin parts, ejector, etc. Parts
assembled improperly
Check the parts for damage or improper assembly
Power reduction or inconsistent
fastener penetra tion barrel is not pulled fully forward when
cycling tool. barrel must be pulled out completely to properly reset
the piston
worn or damaged piston Replace piston or piston ring
Load strip cannot be
inserted into tool Improper loading Insert strip from the bottom of the tool handle
wrong caliber strip Use proper strip
Load strip will not advance worn advance lever guide Replace advance lever guide. This should be performed
by qualified individuals
Load will not fire when
trigger is pulled Tool is not fully depressed follow safety procedure for misfired load then attempt to
fully depress tool before pulling trigger
Load will not fire when tool is fully
depressed and trigger is pulled
Load is already fired Cycle tool
Load misfire follow safety procedure
broken firing pin Replace firing pin nut. This should be performed by
qualified individuals
broken or missing Replace firing pin nut. This firing pin nut should be
Tool cannot be opened
or cycled Lack of proper cleaning Clean tool thoroughly
Damaged or bent piston Remove and replace piston
broken or damaged parts Tag tool with warning “Defective - Do Not Use” place in
locked container and contact your D
E
wALT Authorized
representative for service
Piston stuck in the forward
position Piston has been overdriven and is jammed
against piston reset pin Tap the piston against a hard surface
Chipped or damaged piston Tool not held on work surface squarely.
This allows the piston to slip off the head of
the pin and cause damage to the piston Machine piston as shown on page 11. Piston regrinding
may be performed only by
qualified individuals
Piston guide will not open easily bent shear clip Remove and replace shear clip
Excessive build-up of dirt Disassemble and clean tool
Piston stop is damaged Replace piston stop
foreign material jammed between the
piston guide and steel liner assembly Disassemble and remove foreign particles
Piston guide opens too easily Annular ball spring or steel annular ball
have worn Remove and replace with a new spring and/or ball
#
POW2273_manual_P2201_dewalt.indd 8 3/10/14 12:41 PM