DeWalt DW7464, Инструкция по эксплуатации

Страница: 6 / 24

2
English
T40 TORX
WRENCH (1)
T50 TORX
WRENCH (1)
6 MM HEX
WRENCH (1)
Table saw Preparation: If you purchased the 52" Rail
System as an add-on accessory, start with this section.
If you purchased your 52" Rail System with your DW746
Woodworker’s Table Saw, skip to the assembly section.
• Remove rear rail and associated hardware. If your
saw has an Outfeed Table, remove the rail and any rear
support brackets, but leave the hanger brackets in
place (Fig. 1).
Assembly
If you have other accessories (Slide Table and/or Outfeed
Table) completely assemble the 52" Rail system first,
except for attaching the rear rail. Outfeed Table should be
assembled last.
PLEASE READ ENTIRE ASSEMBLY SECTION
BEFORE PROCEEDING.
STEP 1. Remove parts box, motor cover, fence beam, and
side tables from saw packaging.
STEP 2. Turn the saw right side up.You will need help. The
combined weight of the table top and motor is approxi-
mately 200 lbs.
STEP 3. Cut and remove plastic strap holding the motor.
STEP 4. Using front hand crank, lower the motor some
and remove the foam packing material between the
motor and the mechanism.
STEP 5. Install bevel crank. (Fig. 2) To do this, first install
the crank handle (A) over the shaft (B), rotate slightly to
fully engage the shaft pin. Screw the lock knob (C) into
place until it is fully seated, then back it off 1/4 to 1/2
turn.
STEP 6. Using height crank, raise mechanism up as high
as it will go.
STEP 7. Install wrench hook. (Fig. 3) On the front right
leg, near the top is a plastic threaded insert. Thread
the "L" shaped wrench hook in until only a few threads are
visible.
• Remove front rail by removing the four M10 x 25 flat
head bolts from the top of each front rail bracket.
If your saw has a Sliding Table accessory it will be
necessary to remove M8 x 20 carriage bolts from the
front rail brackets also.
• Remove front rail brackets from the front rail. Loosen
the M8 nuts until only a few threads are holding them in
place.
Slide carriage bolt out of keyslot in rail and
remove hardware from brackets. Retain the front rail
brackets for assembly of your 52" Rail System.
• Remove the motor cover by removing the two screws
and washers from the top of the cover at the top of the
two side legs. Pull the top of the cover away from the
saw and disengage bottom tabs from the slots in the
right crossmember. Re-install the screws and washers
for later use.
• Remove right side support table. Loosen the three
M10 bolts holding the support table to the table saw.
You can now lift the support table up and off. Finish
removing the hardware. (If you are also adding a Slide
Table accessory, the left side support table can be
removed at this time.)
• Continue with Assembly , starting at Step 8.
REMOVE
REMOVE
FIG. 1
A
B
C
FIG. 2
FIG. 3