DeWalt D28415, Оригинальное руководство пользователя

Страница: 36 / 168

ENGLISH
34
4. Press the guard down and rotate it to the
required position.
5. If required, increase the clamping force by
tightening the screw (i).
6. Tighten the clamping lock.
7. To remove the guard, release the clamping lock.
WARNING: Never use the tool without
the guard in place.
NOTE: Please refer to the Grinding Accessory
Chart at the end of this section to show other
accessories that can be used with these grinders.
Fitting and Removing a Grinding Disc
(fi g. 1, 3, 4)
WARNING: Do not use a damaged
disc.
1. Place the tool on a table, guard up.
2. Fit the inner flange (j) correctly onto the spindle
(k) (fig. 3).
3. Place the disc (l) on the flange (j). When fitting
a disc with a raised center, make sure that the
raised centre (m) is facing the flange (j).
4. Screw the outer flange (n) onto the spindle (k)
(fig. 4). The ring on the flange (n) must face
towards the disc when fitting a grinding disc.
5. Press the spindle lock (c) and rotate the spindle
(k) until it locks in position.
6. Tighten the flange (n) with the two-pin spanner
supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (n) with
the two-pin spanner.
Prior to Operation
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and the
tool.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
WARNING:
• Ensure all materials to be ground are
secured in place.
• Apply only a gentle pressure to the
tool. Do not exert side pressure on the
disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Proper Hand Position (fi g. 1)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the side
handle (e), with the other hand on the body of the
tool, as shown in figure 1.
Switching On and Off (fi g. 1)
WARNING: Before using the tool,
check that the handle is tightened
securely.
The on/off switch is equipped with an unlocking
switch.
To run the tool, depress the unlocking switch (b) and
subsequently operate the on/off switch (a).
Release the unlocking switch (b).
To stop the tool, release the switch.
WARNING: Do not switch the tool on
or off when under load.
Spindle Lock (fi g. 1)
The spindle lock (c) is provided to prevent the
spindle from rotating when installing or removing
wheels. Operate the spindle lock only when the tool
is turned off, unplugged from the power supply, and
has come to a complete stop.