15
• Open all packaging with care.
• Once removed from the packaging check the product for any signs of damage.
If damaged do not put into use and contact your provider or Drive DeVilbiss
Healthcare Ltd. (See Section 2).
• Remove all covers, sheets and the existing mattress/cushion from the bed/chair.
• Position the mattress on top of the bed frame, top cover facing upwards and air
hose at the foot of the bed for control unit positioning.
• If using a cushion, position the cushion onto a fixed chair which has a padded
seat, with the top cover facing upwards and air hose at a rear corner of the seat
for control unit positioning.
• If using the mattress attach to the bed frame by securing the adjustable straps
to the moving sections of the bed.
• If using the cushion, loosely secure the cushion to the chair frame by using the
attached securing straps.
• For profiling beds, it is essential that the straps
are secured around the movable sections of
the bed frame – Damage will be incurred when
profiled if secured to fixed parts of the frame.
• To avoid any risk of damage to the mattress
ensure there are no sharp objects which may
come in contact with it.
• Ensure the CPR dial is rotated to a vertical or horizontal, closed position.
• Attach the male air connector to the control unit,
ensuring the air hose does not kink or become
trapped between parts of the bed frame.
• Route the mains cable down the length of the
mattress using the integral routing sheath. Detach
the pop studs from the sheath, insert the cable
and reattach all the studs down the full length of
the sheath. See steps 1 to 3 below.
• Position the control unit by hanging
the hooks over the foot board. If
there is no foot board place the unit
on the floor with the front facing
upwards. Ensure the rear of the unit
is not obstructed by carpet, rugs etc.
It is advisable to place the unit on a
firm surface.
CPR Closed:
CPR Open:
