Panic Button - PBTZB-110
–
Technical manual
Develco Products A/S
Tangen 6
http://develcoproducts.com
DK-8200 Aarhus N
15
5
MMI user guide
The MMI menu allows the user to perform various operations on the device. Its use is explained in section 5.2 Push
Button Menu
5.1
Accessing and re-enabling MMI menu
The MMI menu is accessible while the device is initially scanning for a network. When the device joins a network,
the MMI menu is accessible for an additional 60 seconds. After this point, the MMI menu is inaccessible. To re-
enable the MMI menu, use one of the two methods below.
WARNING: Using method 1 will temporarily put the device into alarm state until the MMI menu becomes active. If
this is of concern, method 2 can be used instead.
Method 1:
•
Press and hold the button for 10 seconds. When the LED flashes green, release the button immediately
Method 2:
•
Remove the battery, wait 10 seconds and re-insert it into the device
5.2
Push Button Menu
When MMI menu is active the user can push the button and select the different menus described below. Pushing
the button for longer (push, hold for a few seconds, and release) allows the user to set the device into a desired
mode. A mode change happens at 5 second interval. Below, these modes are illustrated in a state chart.
Idle
EZ mode
Initiator
EZ mode
Target
Factory reset
Push + Hold button
untill led blinks once
Push + Hold button
untill led blinks
continously
Push + Hold button
untill led blinks
twice
Push + Hold button
untill led is off
When cycling through the menu modes, the state is indicated by a number of 100ms blinks on the LED. The
device is supporting the ZigBee standardized EZ- mode Commissioning.
