Dettson AMT400B34-SM1PMA, Инструкции по установке и руководство для владельца

Страница: 12 / 45

12
4.7 MOTOR LUBRICATION
Do NOT lubricate the oil burner motor or the direct drive
blower motor as they are permanently lubricated.
4.8 PULLEY ALIGNMENT
Align the motor pulley and the blower pulley by moving
the motor on the blower rail. Set a straightedge on the two
pulleys and check if the blower belt is perfectly parallel to
it (refer to Figure 4).
Figure 3 – Pulley adjustment
4.9 BELT REPLACEMENT
Check the blower belt for wear and replace if necessary,
using the two adjustment screws located near the motor
base. ALWAYS remove the belt tension before replacing it.
NEVER use a screwdriver to remove or install a belt. This
can damage the pulleys and other components.
Belt tension verification
I
deally, belt tension should be checked with an appropriate
gauge. If such a tool is not available, the tension can be
checked by applying pressure to it in the centre between
the pulleys. The belt displacement should be about 25.4
mm (1") (refer to Figure 4.1). Adjust the belt by using the
two adjustment screws located near the motor base.
Figure 4 – Belt tension verification
CAUTION
Excessive belt tension is the most frequent
cause of bearing wear and resulting noise.
Check for proper belt adjustment.
DNS-0853 Rev. A