- 11 -
Focusing the projection and adjusting the image
1. Remove the lampshade on the side which holds the screw securing the lens holder. Carefully
slide the lampshade out of its housing and put it to the side.
2. Losen the screw on the lens holder, until it can be moved within the housing together with the lens
(see Fig.
10
a).
3. Switch on the projection light and screw the lens in the correct position, until the projected motif
forms a sharp picture (see Fig.
10
b).
4. Then tighten the screw, until the lens holder cannot be moved in the housing any more (see Fig.
10
a).
Note: Turn the projection motif (Gobo) immediately after switching on the lamp, as by then
the lamp has not yet heated up the projection motif (Gobo) too much.
5. Turn the Gobo – Projection Motif inside the Gobo retainer, until the projected motif has been
correctly adjusted. In order to do that, touch the Gobo with your finger from underneath and turn it
into the desired position. In case your are having difficulties turning the Gobo, gently push up with
your finger to release it. Do not reach into the Gobo retainer from the top, as you may accidentally
touch the hot lighting element.
6. Carefully slide the lampshade back into its housing (see Fig.
13
).
Fig. 10: Focusing
a b
Содержание bil
Страница 1: ...Reference Manual 115V ...
Страница 2: ... 2 Illustration 1 ...
