Derksen bil, Справочное руководство

Страница: 14 / 20

- 14 -
Replacing the lighting elements
Take care not to come into contact with the hot lighting element and bulb fittings while the equipment
is in operation. Before you replace the lighting element, switch off the equipment and wait for about 15
minutes for it to cool down.
Only use replacement multi-mirror bulbs that have been tested and approved by Derksen Lichttechnik
GmbH. Should the BIL be fitted with an unsuitable bulb, the equipment can become damaged or the
motive will be projected in poor quality.
Approved and tested lighting elements:
- PHILIPS Brilliant Line Pro 12V, 50W, 24°
- BLV Eurostar 12V, 50W, 24°
- OSRAM Dekostar Titan 12V, 50W, 24°
- Sylvania Superia 12V, 50W, 24°
Important: The lighting element must have a reflected beam angle of 24°!
1. Switch off the projection light. Wait until the lighting element has cooled down.
2. Remove the lampshade on one side. Carefully slide the lampshade out of its profile and put it to
the side.
3. Remove the old lighting element from the socket by slightly tilting it and carefully sliding it out of
its socket. Make sure not to bend the 2 retaining clips too much. There is enough space between
the Gobo retainer and the socket to change the lighting element without altering the Gobo
retainer’s position.
4. Carefully set the new lighting element in its socket in the same way (see Fig. 14).
5. Carefully slide the lampshade back into its profile (see Fig.
13 ).
Fig. 14: Inserting or changing the lighting element
W