Derby cycle PEDELEC IMPULSE 2.0 ERGO, Руководство пользователя

Страница: 17 / 34

Original User Manual | Pedelec Impulse 2.0 Ergo 17
Locking the battery
DOWN TUBE BATTE RY SE AT TUBE BATTERY
3. Make sure the battery is firmly in place.
5.2 Battery information system
There is a display panel on the outer face of the battery
which includes five LEDs and a battery key | push button.
The LEDs light up as soon as you press the battery key
| push button. The charge state and capacity of the battery
is indicated by the number of LEDs that light up and the
way in which they light up.
Battery key Push button
DOWN TUBE BATTERY SEAT TUBE BATTERY
5.2.1 Checking the charge state
a) Down tube battery: Press the battery key briefly. The
LEDs light up and display the current battery charge state.
DISPLAY BATTERY CHARGE STATE
••••• 5 LEDs light up 100-80%
•••• 4 LEDs light up 80-60%
•••
3 LEDs light up 60-40%
•• 2 LEDs light up 40-20%
• 1 LED lights up 20-10%
¡
1 LED flashes 10-0%
b) Seat tube battery: Press the push button briefly. The
LEDs light up and display the current battery charge state.
.
SEAT TUBE BATTERY DISPLAY BATTERY CHARGE STATE
••••• 5 LEDs light up 100-84%
••••
4 LEDs light up 83-68%
••• 3 LEDs light up 67-51%
•• 2 LEDs light up 50-34%
•
1 LED lights up 33-17%
¡
1 LED flashes 16-0%
5 LEDs flash quickly 0% or overloaded *
1st LED flashes
quickly Charging fault **
* All 5 LEDs flash quickly: The battery is a) empty and is
being switched off, or is b) overloaded.
a) If the battery is overloaded, it will switch back on after
a short idle period and can then be used normally.
b) If the battery is empty, it will work again briefly fol-
lowing a short period of rejuvenation and will then
switch back off. It must now be charged.
** The 1st LED flashes quickly: a charging fault.
If this occurs, put the battery in the docking station for a
short period of time or insert the plug of the charger into
the battery. The charger performs a readjustment. If the
LED still flashes, take the battery to your specialist cycle
shop.
5.2.2 Checking the capacity
a) Down tube battery: If you hold down the battery but-
ton for roughly five seconds, the LEDs show the current
battery capacity. If the LED in the largest panel lights up,
then the battery has a capacity of over 60%. If the capac-
ity is below 60%, this is indicated via the smallest LED.
Only one of the two LEDs can light up at any one time.
b) Seat tube battery: If you press the push button for five
seconds, the LEDs show the current capacity of the bat-
tery.
SEAT TUBE BATTERY DISPLAY CAPACITY
•••••
5 LEDs light up 100-97%
•••• 4 LEDs light up 96-80%
••• 3 LEDs light up 79-60%
••
2 LEDs light up 59-40%
• 1 LED lights up 39-20%
¡
1 LED flashes < 20%