Deprag SZG Controller 6, Руководство по эксплуатации

Страница: 32 / 48

SZG CONTROLLER 6 - ENGLISH
32
11 Functions and settings
11.1 Reload
If there is no feed part in the nosepiece then a feed part can be manually reloaded.
If the buttons or are pressed on feeders type 1611 or 1622 the reload procedure is started via the
separator. On feeder type 1611 only the button has a function, on feeder type 1622 both buttons are
functional, each button corresponds with a side of the separator.
11.2 Fill run
After the vibratory bowl has been emptied and new feed parts have been added, these parts can be
manually run to the top of the bowl.
If the button is pressed then the vibratory bowl is activated. The bowl switches off automatically after 5
seconds.
11.3 Test functions
The correct function of the inputs and outputs of the controller as well as the bowl controller can be checked
in the menu TEST FUNCTIONS.
11.3.1 Inputs/Outputs
In the submenu INPUTS the inputs from 1 to 6 are listed (see headline INPUTS). If an input is set to 1 then
on the display 1 is shown for the input.
In the submenu OUTPUTS the outputs from 1 to 8 are listed (see headline OUTPUTS). If an output is
selected via the arrow buttons ( and ) and then the value 1 is set using the button then the
corresponding output is activated. If for example the output 1 is set then the air-push is activated. Press the
button again to set the output back to 0.
11.3.2 Vibratory bowl
In the submenu BOWL the vibratory bowl can be started and stopped. Press the button to start the bowl
and press the button again to stop the bowl.
11.4 Restore factory settings
In the menu section SUPPL. CONDITION the factory settings from DEPRAG can be restored.
The following settings are then replaced with the factory set values:
•
All user-dependant times
•
Password
•
Display screen
•
Soft start
•
Operation without load control (strain gauge)