Deprag 330EG36-0012, Руководство по эксплуатации

Страница: 17 / 32

9 Screwdriving template
5 screw assembly and 5 loosening programs can be adjusted.
9.1. Description of the screwdriving sequences
9.2. Screw assembly program
Structure of the screw assembly program:
Search
run:
A1 Speed
A2 Target angle
A3 Target torque
Screw assembly to torque:
A4 Speed
A5 Target torque
Screw assembly / Loosening to angle:
A6 Direction
A7 Speed
A8 Angle
The individual steps can be deactivated independently from each other. In this case the
following parameters should be set to zero:
Search
run: Shut-off angle
Screw assembly to torque Shut-off torque
Screw assembly / Loosening to angle: Shut-off angle
Search run
The screwdriving template search run can be used to make contact/insertion easier.
When beginning the screwdriving step time monitoring and angle measurement are
started. Cyclical torque measurements are carried out.
The screwdriving sequence is ended once the shut-off angle or shut-off torque has been
reached or the maximum screwdriving time is exceeded.
The screwdriving step is recorded as OK (error free) if shut-off via angle or torque is suc-
cessful.
The screwdriving step is recorded as NOT OK (errors present) if the torque is outside the
set limits or the screwdriving time is exceeded.
The following parameters are used in the screwdriving template:
• A1 - Speed: adjustable (10% to 100% of the maximum screwdriver speed)
• A2 – Shut-off angle: adjustable (0 to 990 *10 degrees)
• A3 – Shut-off torque: adjustable (0 to maximum screwdriver torque)
• Torque upper limit: 120 % of the shut-off torque
• Angle lower limit: Shut-off angle - 10°
• Angle upper limit: Shut-off angle + 10°
• Maximum time: 10 s
Screw assembly to torque
The screwdriving template screw assembly to torque is a tightening procedure with shut-
off to torque. Cyclical torque measurements are carried out.
The screwdriving sequence is ended once the shut-off torque has been reached.
17