Deprag 330EG36-0012, Руководство по эксплуатации

Страница: 10 / 32

WARNING
Disconnect screwdriver from power supply before changing or mount-
ing the screwdriver tool (bit, socket) or accessory.
CAUTION
Screwdriver will heat-up in relation to its average load respectively se-
quence of operation If the selection of the type of screwdriver is incorrectly
or its operation is not appropriate for the application, the tool might overheat
which could result in injuries (burnings).
6.3. Change of Bits
DANGER
Machine can start. Serious injuries could be caused.
Disconnect the machine from the electricity supply.
IMPORTANT
Use perfect inserting tools (e.g. bits) and connecting components with
DIN 3126 – E6.3 (¼”) external hexagon end only.
The EC-screwdriver is equipped with a quick change chuck.
1. Pull the sleeve forward towards the tip of the screwdriver spindle and insert new bit or
remove old bit.
2. Push the new bit (E6.3 (¼“)) into the hex until it locks.
3. Let sleeve snap back.
sleeve
Illustration 5 – Change of Bits
10