40
6.
If the baud rate was changed for the firmware update, restore the baud rate to its original
setting.
OPTIONAL: When the firmware update completes and if the I/O connections are not in use counting
input pulses or generating output pulses, the I/O LED turns on. This behavior is due to the new control
feature for the I/O in this firmware version. Having the I/O LED on for unused I/O does not affect meter
operation. There are two methods available to turn off the LED. Only one method needs to be
completed.
Method 1 - Set the control output to disable the LED:
•
Set register 44402 = 1 (for I/O 1), 44403 = 1 (for I/O 2).
•
Wait 60 seconds before power cycling the PowerScout 3, to save the settings.
Method 2 - Enable input pulse counting:
•
Set register 45100 = 1 (for I/O 1), 45200 = 1 (for I/O 2).
•
No waiting is required. The input configuration is applied immediately and saved.
This completes the firmware update for the PowerScout 3.
Содержание PowerScout 3
