Denso AT10Q-SM, Руководство пользователя

Страница: 52 / 113

42
8.2 Indicator LED
The indicator LED lights or flashes in blue, green, red or orange as described below.
The indicator LED lights in blue when:
- the scanner has read a code successfully,
- the "Start setting" or "End setting" code is read from the QR-coded parameter menu (given in Chapter 12),
- the scanner starts or ends a sequence of split QR Code scanning,
- the scanner has read a split QR Code symbol,
- the parameter values are saved by a PW command (refer to Appendix 2),
- code data read matches the master data in the data verification mode, or
- master data has been successfully registered in the data verification mode.
The indicator LED lights
in green when:
- the scanner is ready to register master data.
The indicator LED lights
in red when:
- the scanner has received an abnormal control command,
- the scanner has failed to edit data read,
- code data read does not match the master data in the data verification mode,
- a master code has the wrong number of digits during registration of master data,
- the scanner has read split QR Code symbols in edit mode and the accumulated data exceeds 8 kilobytes,
- the scanner has failed to save parameter values specified with the configuration software (ScannerSetting_2D),
QR-coded parameter menu, or control commands,
- a code other than a parameter setting code is read during parameter setting by the QR-coded parameter menu,
- a transmission error or timeout occurred when the scanner was communicating with the configuration software
(ScannerSetting_2D),
- a run-time error has occurred in ADF script, or
- the trigger switch is pressed when the trigger switch control is disabled.
The indicator LED
flashes in red when:
- no master data has been registered in the data verification mode.
The indicator LED lights
in blue and orange alternately when:
- the interface has switched between the RS-232C and USB interfaces by turning the scanner power on with the
trigger switch held down.