123
System call
(1) System call buttons
Up to 32 signals each can be stored at
the SYSTEM CALL 1 ~ 3 buttons.
The System Call function can be used
in the SYSTEM CALL mode.
(2) Storing system call signals
1
2
5
Press and hole the RC SETUP button for at
least three seconds.
• The IR segment blinks twice.
Press the “9, 7, 8” button (9
→
7
→
8) to select system
call setting.
• The IR segment blinks
twice.
Repeat steps 4 to register the desired buttons.
Up to 32 signals each can be stored at the SYSTEM CALL
1 ~ 3.
1, 6
2
IR segment
4
3
The accessories remote control unit is equipped with “system call” function allowing a series of remote control signals to be transmitted by
pressing a single button.
This function can be used for example to turn on the amplifier’s power, select the input source, turn on the monitor or TV’s power, turn on the
source component’s power and set the source to the play mode, all at the touch of a single button.
3
4
Press the button you want to register.
• The IR segment blinks once after each button press.
The mode can be switched by pressing a mode selector
button.
Press the SYSTEM CALL button
(1 to 3) you want to register the
system call.
6
Press and hold the RC SETUP button for at
least three seconds to register the system
call.
• The IR segment blinks twice.
NOTE:
• The remote control signals of the buttons pressed while
registering the system call signals are emitted, so be careful not
to operate the components accidentally (cover the remote
sensors, for example).