Delta 22-610, Инструкция по эксплуатации

Страница: 18 / 64

18
4"
1
/
4
"
45°
2"
3"
4"
1
1
/
2
"
1
/
2
"
GRAIN
C A
A
B
ADJUSTINg THE CHIP DEFLECTOR
B
1. Remove the cutterhead guard.
2. Adjust the edge (C) of the chip deflector (A) Fig. 42
so that it is a minimum of .040" and a maximum of
.080" away from the cutting circle. Place a feeler
gauge between the knife and the edge of the chip
deflector (Fig. 38). To adjust, loosen the three screws
(B) and move the chip deflector.
ADJUSTINg THE TABLE HEIgHT SCALE
The table height scale indicates the distance from the table to the cutting circle (depth-of-cut).
To check and adjust the pointer:
1. Run a piece of wood part way through the planer and stop the machine.
2. Measure the thickness of the finished piece. To adjust, loosen the two screws (A) Fig. 43, adjust the pointer (B),
and retighten the screws (A).
gAUgE BLOCk
A gauge block has been supplied with your planer. However, if you would like to make one out of hardwood, follow the
instructions shown in Fig. 44.
Fig. 42
Fig. 43
Fig. 44