P0522
DELTA WATER ENGINEERING
V01/2017/P4
3.
Installation:
3.1
Close main valve and make sure pressure is released from piping. This can
be done by opening at least one tap.
3.2
Cut open main water supply in order to install direct connections to the
Delta Softener or to install the Delta Bypass (recommended). Follow the
arrows on both Bypass and softener for water inlet and outlet.
Pay attention that the inlet filter doesn’t fall out.
With Delta Bypass
With direct connections
The Delta Bypass has a ¾” connection. The
direct connections on the water softener
are available in ½”, ¾” and 1”.
Caution: before installing the softener, set
the Bypass in “bypass” mode, not in
“service”.
3.3
Connect the straight outlet (#12) to a
local drain (with an air gap, using the
provided D.O.D. (Delta Open Drain),
see par. 3.5) by means of the provided
13mm flexible drain pipe. In order to
guarantee that the device will keep on
functioning perfectly in the future, this
drain pipe is spirally reinforced to avoid
later blocking and/or kinks. Please protect
the drain against frost and heat (min.
temp. 5°C, max. temp. 40°C).
When another drain pipe is used, the
guarantee on the unit is expired.
