28
GB/MT
• Warning! Batteries may not be
charged or reactivated by
other means and may not be
dismantled, thrown in the fire,
or short-circuited.
• Always store the batteries out
of the reach of children.
• Batteries that are not recharge-
able may not be charged.
• Rechargeable batteries may
only be charged under adult
supervision.
• Rechargeable batteries must be
removed from the article before
they are charged.
• The terminal clamps may not
be short-circuited.
• Please handle a damaged or
dead battery with extreme care
and dispose of it correctly,
wearing gloves.
• If you come into contact with
battery acid then wash the re-
levant area with water and
soap.
If battery acid gets in your eyes
rinse them out using water and
consult a doctor immediately.
Assembly
Assembly of foot parts (figure B)
1. Remove the packaging materials.
2. Turn the article over so that the underside is
facing upwards.
3. Screw the small foot (2) to the article using
2 x screws (5) and washers (6) with the help
of the Allen key (7).
Note:
The small foot must be fitted at the front
where the resistance screw (1a) and the display
(1b) are located (figure E).
4. Screw the large foot (3) onto the article with
two screws and washers.
Assemble pedals (figure C)
When assembling the pedals please ensure that
the right pedal is mounted on the right pedal
crank and the left pedal on the left pedal crank.
The letter
R
is printed on the right pedal crank
and the letter
L
on the left pedal crank as guides.
Note:
Turn the pedal crank upwards to make it
easier to mount the pedals.
1. Stand the article on the feet.
2. Insert the thread end into the threaded hole
on the pedal crank.
3. Hold the pedal tight in the thread on the
pedal crank with one hand and turn it with
the other hand using the wrench until it is
tightly attached to the pedal crank.
Caution!
Turn the right pedal to the right and the
left pedal to the left to tighten.
Adjust pedal straps (figure D)
The pedal straps (4b) are pre-fitted. You have
the choice of adjusting the straps to one of two
lengths.
1. Release the two screws (4c) from the pedal
end (4a) using the Allen key with a screw-
driver (7).
2. Select the holes on the strap end that corres-
pond to your chosen length and re-tighten the
screws on the pedal end.
Содержание CRIVIT AT-2154
Страница 2: ...1 2 3 4 5 6 7 8 A 2 3 1 5 6 5 6 B 4 4 1 C 4c 4b 4a D 1a E 1b F 1b 1c 1d 1e G I J 1b 1d 1e H ...
Страница 36: ...38 ...
Страница 37: ...39 ...
Страница 38: ...40 ...
