DELTA DORE CS 2000 TYXAL+, Руководство пользователя

Страница: 14 / 44

- 14 -
3.5 Triggering of an SOS with siren
Press and hold the
SOS button for 2 seconds.
The LED changes from red to green to confirm the
action.
The alarm control unit emits a BEEP.
The SOS with siren triggers:
- a call cycle from the transmitter to the programmed
numbers (starting with the 1
st
number).
- an audible signal from an associated siren.
To stop an active emergency alarm with siren, enter the access code then
press OFF.
3.6 Clearing defects
Each time the system is activated or deactivated, the alarm control unit will
inform you that an event (or defect) is stored by using a series of beeps or a
refusal to switch on. These events (intruder detection, product de-
fect, open entry, etc.) can be cleared so as not to be signalled by the
control unit.
The system must be off.
If you do not have a touch screen keypad, you can
clear defects by using the simple keypad:
Ê
Enter your access code.
Ë
Press and hold the button for 5 seconds.
The LED changes from red to green to confirm the action.
The alarm control unit emits a series of beeps, stops, then emits
one more beep.
3.7 Disabling audible beeps for the button
Press and hold the button for 5 seconds until
the green LED comes on.
>2s
OK
SOS
+
1 2
>5s
OFF
To enable the beeps again, press
the
button for 5 seconds.
>5s >5s
3. Use with your simple keypad
This function is used to trigger a call with your
telephone transmitter to warn relatives that you are in a situation
of distress. It also sets off the sirens with a specific tone.