10
CHOOSING A LOCATION FOR YOUR KILN
The proper location is as important as choosing the right kiln. Below are some safety
guidelines.
o
Please review the safety considerations listed on page 5 when selecting a
location for your kiln.
o
Your kiln should be located in a covered, dry, fireproof and well ventilated area,
but
never
in a small enclosed area such as a closet, cabinet or very small room.
Otherwise, the room temperature will increase past a reasonable level quickly. In
a larger room, the exterior of the kiln will stay cooler than in a very small room.
o
Your kiln should be on a cement or fireproof surface and positioned a minimum
of 12” from any surface. The best and safest place for your kiln is on a cement
floor. If not, some type of adequate fireproof material should be used beneath
the kiln to prevent a possible fire hazard or prevent discoloration of the floor.
o
Concrete blocks 8” x 8” x 16”, with holes up, may be used to raise the kiln to a
higher level. Solid bricks transfer heat through to the floor and should not be
used.
o
Air circulation and ventilation are needed to remove heat and vapors that may be
released from the firing. In a larger room, the exterior of the kiln will stay cooler
than in a very small room. If ventilation is a problem, call to see if an Orton Vent
System or a hood system is applicable.
o
Proper electrical service must be available. Refer to the section on Electrical
Specifications. Select a grounded, three-pronged receptacle that is as close as
possible to either your fuse or breaker box. DO NOT use extension cords!
o
Remove all flammable or combustible materials such as gasoline, paper, paints,
plastics, etc. from the surrounding area.
o
Since the exterior of the kiln gets very hot, place the kiln out of the way of
children, traffic, and work areas.
o
Do not let the power cord come in contact with the kiln. The kiln may need to be
rotated a little for the cord not to touch the kiln.
o
Never install a kiln outside and avoid undue moisture.
