Dell SP2309W, Руководство пользователя

Страница: 32 / 36

Back to Contents Page
Troubleshooting
Dell™ SP2309W Flat Panel Monitor
Self-Test
Common Problems
Product Specific Problems
Universal Serial Bus Specific Problems
Dell Soundbar Problems
Camera Problems
Self-Test
Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly
connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer or monitor. To ensure proper Self-Test operation, remove HDMI, Digital (white connector), and the
Analog (blue connector) cables from the back of the computer or monitor.
3. Turn on the monitor.
4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged.
5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning
properly.
Built-in Diagnostics
Your monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, or
with your computer system and graphic card.
To run the built-in diagnostics:
1. Ensure that the screen is clean (no dust particles on the surface of the screen).
2. Unplug the video cable(s) from the back of the computer or monitor. The monitor then goes into the self-test mode.
3. On the front panel, touch and hold the shortcut key 1 and shortcut key 4 keys on the front panel, simultaneously for 2 seconds. A gray screen
appears.
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions .
The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.
While in self-test mode, the power LED remains white. Also, depending upon the selected input, one of the dialogs shown below will continuously
scroll through the screen.
or
or
NOTE: You can run the built-in diagnostics only when the video cable is unplugged and the monitor is in self-test mode .