6. Align the edge of the memory module connector with the alignment key on the memory module
socket, and insert the memory module into the socket.
ATTENTION
The memory module socket has an alignment key that allows you to install the memory
module in the socket only in one way.
7. Press down the memory module with your thumbs while pulling up on the socket ejectors with your
index fingers to lock the memory module into the socket.
When the memory module is properly seated in the socket, the socket ejectors on the memory
module socket align with the socket ejectors on the other sockets that have memory modules
installed.
8. Close the top cover.
9. Replace the server in the cabinet.
10. Connect the power cords and cables to the back panel of the server.
11. Press the Power On/Off button on the server, to turn on the power.
5.3
Installing hot spare hard drive
You can insert the hot spare hard drive when the server in on.
5.3.1
To insert the hot spare hard drive
1. From the front end of the server, locate the blocking plate at the fifth bay (marked as 4).
2. Press the latches located at the ends of the blocking plate and pull the blocking plate.
Figure 5.4 Pull the Blocking Plate
3. Remove the blocking plate.
Figure 5.5 Removal of Blocking Plate
- 41 -
Chapter 5 - Servicing
