Dell PowerEdge 6350, Инструкция по установке и устранению неисправностей

Страница: 119 / 205

Installing System Board Options 8-9
&$87,21 0DNH VXUH WKH PHPRU\ PRGXOH LV FRPSOHWHO\ VHDWHG LQ WKH V\V
WHP ERDUG FRQQHFWRU EHIRUH DSSO\LQJ SRZHU ,QFRPSOHWH LQVHUWLRQ FDQ
GDPDJH WR WKH V\VWHP ERDUG DQG PHPRU\ PRGXOH
7. Close the computer panel doors, reconnect the computer and peripherals to their
power sources, and turn them on.
After the system completes the power-on self-test (POST) routine, it runs a mem-
ory test that displays the new memory total, which includes all newly installed
memory.
NOTE: If the memory total is incorrect, turn off and disconnect the computer and
peripherals from their power sources, open the computer panel doors, remove
the memory module, and check all the installed DIMMs to make sure they are
seated properly in their sockets. Then repeat steps 6 and 7.
The system detects that the new memory does not match the system configura-
tion information, which is stored in nonvolatile random-access memory
(NVRAM). The monitor displays an error message to that effect, ending with the
following words:
Press <F2> to enter System Setup.
8. Press <F2> to enter the System Setup program, and check the Extended Memory
category in the Main menu of the system setup screens.
See Chapter 4, “Using the System Setup Program,” in the system User’s Guide
for more information.
The system should have already changed the value in the Extended Memory
category to reflect the newly installed memory. Verify the new total.
NOTE: The value of extended memory is given in kilobytes. To convert kilobytes to
megabytes, divide the kilobyte total by 1024.
If the total is incorrect, one or more of the DIMMs may not be installed properly.
Repeat this procedure, checking to make sure that the DIMMs are firmly seated
in their sockets.
9. Enter the system configuration utility. Then save the configuration and exit the
utility.
Running the system configuration utility and saving the configuration is required
for the system to recognize the newly installed DIMMs. See Chapter 5, “Using
the System Configuration Utility,” in the system
User’s Guide for instructions on
running the utility and saving the configuration.
10. Run the RAM Test Group in the Dell Diagnostics.
See Chapter 5, “Running the Dell Diagnostics,” for information.