Dell PowerConnect J-8208, Руководство по оборудованию

Страница: 123 / 276

6.
In a four-post rack, carefully slide the switch onto the adjustable mounting brackets
until the front-mounting brackets (“ears”) attached to the chassis contact the rack
posts. The adjustable mounting brackets installed in the rack ensure that the holes
in the front-mounting brackets align with the holes in the rack posts.
In a two-post rack, carefully slide the switch into the rack ensuring that the front
bottom of the chassis rests on the lip of the power cord tray. The front-mounting
brackets (“ears”) prevent the chassis from tipping too far back.
7.
Move the lift away from the rack.
8.
In a four-post rack, slide the chassis so that the front-mounting bracket is flush with
the front of the rack.
In a two-post rack, push the bottom of the chassis so that the front-mounting bracket
is flush with the front of the rack.
9.
Install a mounting screw—plus a washer if you installed cage nuts—into each of the
open front-mounting holes aligned with the rack, starting from the bottom.
10.
Visually inspect the alignment of the switch. If the switch is installed properly in the
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the switch is level.
11.
After ensuring that the switch is aligned properly, tighten the screws.
Related
Documentation
Powering On a J-EX8200 Switch on page 133
•
•
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144
•
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146
Mounting a J-EX8208 Switch on a Rack or Cabinet Without Using a Mechanical Lift
If you cannot use a mechanical lift to install the switch (the preferred method), you can
install it manually.
CAUTION: The chassis with only the backplane and no other components
weighs approximately 89 lb (41 kg). Lifting the chassis and mounting it in a
rack or cabinet requires at least three people.
The chassis has two handles. Do not lift a fully loaded chassis by the handles;
make sure the chassis is empty (contains only the backplane) before you lift
it. If two of the people lifting the chassis use the handles to lift it, the third
person must lift from the rear of the chassis. The rear of the chassis is heavier
than the front of the chassis, so when you lift the chassis by the handles, the
chassis tips toward the heavier back end. The person lifting from the back
must be aware of this behavior and must be braced to prevent the chassis
from tipping over.
When lifting the chassis, do not grasp the switch by the blue panel at the top
front of the chassis. Doing so can cause the panel to pop off of the switch.
107
Chapter 8: Installing the Switch