Steps
1. Slide the I/O board into the slots on the palm-rest and keyboard assembly.
2. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x2) that secures the I/O board to the palm-rest and keyboard assembly.
4. Connect the power-button with optional fingerprint reader cable into the connector on the I/O board and close the latch to
secure the cable.
5. Connect the coin-cell battery cable to the I/O board.
6. Connect the I/O-board cable to the I/O board and close the latch to secure the cable.
7. Adhere the tape that secures the I/O-board cable to the I/O board.
8. Close the left display hinge.
9. Replace the three (M2.5x4.5) screws that secure the left display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
network-port bracket
.
2. Install the
base cover
.
3. Exit
Service Mode
.
4. Follow the procedure in
After working inside your computer
.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Enter
Service Mode
.
3. Remove the
base cover
.
44
Removing and installing components