Dell OptiPlex 3020-Mini Tower, Руководство пользователя

Страница: 51 / 59

Error Message Description
Bad command or
file name Ensure that you have spelled the command correctly, put spaces in the proper
place, and used the correct pathname.
Bad error-
correction code
(ECC) on disk read The floppy or hard drive controller detected an uncorrectable read error.
Controller has
failed The hard drive or the associated controller is defective.
Data error The floppy or hard drive cannot read the data. For the Windows operating system,
run the chkdsk utility to check the file structure of the floppy or hard drive. For
any other operating system, run the appropriate corresponding utility.
Decreasing
available memory One or more memory modules may be faulty or improperly seated. Re-install the
memory modules and, if necessary, replace them.
Diskette drive 0
seek failure A cable may be loose or the computer configuration information may not match
the hardware configuration.
Diskette read
failure The floppy disk may be defective or a cable may be loose. If the drive access light
turns on, try a different disk.
Diskette
subsystem reset
failed The floppy drive controller may be faulty.
Gate A20 failure One or more memory modules may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them.
General failure The operating system is unable to carry out the command. This message is usually
followed by specific information—for example,
Printer out of paper . Take the
appropriate action to resolve the problem.
Hard-disk drive
configuration
error The hard drive failed initialization.
Hard-disk drive
controller failure The hard drive failed initialization.
Hard-disk drive
failure The hard drive failed initialization.
Hard-disk drive
read failure The hard drive failed initialization.
Invalid
configuration
information-
please run SETUP
program The computer configuration information does not match the hardware
configuration.
Invalid Memory
configuration, DIMM1 slot does not recognize a memory module. The module should be re-
seated or installed.
51