Display Bezel
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
display assembly
.
3.
Use a plastic scribe to pry the six round display bumpers out of the screw holes located on the front of the bezel. Do not remove the oval bumpers.
4.
Remove the six M2.5 x 5-mm screws located on the front of the bezel under the bumpers.
5.
Separate the bezel from the top cover by lifting the inside edge of the bezel away from the top cover.
Pull the bezel from the top edge toward the center of the panel to open the snaps. Push the bezel on the sides and bottom away from the center of the
panel to open the snaps.
1 display
2 pull-tab
3 display cable connector
4 antenna cable
5 computer base
6 system board connector
for display cable
CAUTION:
Before performing the following procedures, read the safety instructions in your
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Carefully separate the bezel from the top cover to avoid damage to the bezel.
NOTE:
You may need to use a plastic scribe to begin the separation.
NOTICE:
To avoid damaging the bezel, start pulling the bezel up near the bottom of the display (near the Dell™ logo) and work around the display and
toward the release latch.
Содержание Latitude D810
Страница 5: ...Back to Contents Page Internal card with Bluetooth wireless technology 1 each Button Board 2 each ...
Страница 25: ...Back to Contents Page ...
Страница 27: ...Back to Contents Page 1 M2 5 x 5 mm screws 2 2 keyboard 3 palm rest 4 keyboard tabs 5 ...
Страница 41: ...When replacing the thermal cooling assembly follow the steps in reverse order Back to Contents Page ...
