Back to Contents Page
Before You Begin
Dell™ Latitude™ D810 Service Manual
Preparing to Work Inside the Computer
Recommended Tools
Computer Orientation
Screw Identification
Preparing to Work Inside the Computer
1.
Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2.
Save any work in progress and exit all open programs.
3.
Turn off the computer and all attached devices.
4.
If the computer is connected to a docking device, undock it.
5.
Disconnect the computer from the electrical outlet.
6.
To avoid possible damage to the system board, wait 10 to 20 seconds and then disconnect any attached devices.
7.
Disconnect all other external cables from the computer.
8.
Remove any installed PC Cards from the PC Card slot.
9.
Close the display and turn the computer upside down on a flat work surface.
10.
Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the bay.
11.
Remove any installed
memory modules
,
MiniPCI cards
, and
modules
, including a second battery if one is installed.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in Dell's product documentation, or as directed by Dell's online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface.
NOTICE:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal
mounting bracket. Hold a component such as a microprocessor by its edges, not by its pins.
NOTICE:
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
NOTE:
Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the computer operating
system, press and hold the power button for 4 seconds.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you service the computer.
Содержание Latitude D810
Страница 5: ...Back to Contents Page Internal card with Bluetooth wireless technology 1 each Button Board 2 each ...
Страница 25: ...Back to Contents Page ...
Страница 27: ...Back to Contents Page 1 M2 5 x 5 mm screws 2 2 keyboard 3 palm rest 4 keyboard tabs 5 ...
Страница 41: ...When replacing the thermal cooling assembly follow the steps in reverse order Back to Contents Page ...
