8.
Use the touch pad connector tab to disconnect the touch pad connector from the system board.
9.
Starting at the back center of the palm rest, use your fingers to separate the palm rest from the computer base by gently lifting up the palm rest while
pressing down on the back of the computer base.
Replacing the Palm Rest
1.
Align the palm rest with the bottom plastics and gently snap it into place.
2.
Reconnect the touch pad connector to the system board.
3.
Replace the four M2.5 x 5-mm screws on the top of the palm rest.
4.
Turn the computer upside-down, and replace the 14 M2.5 x 8-mm screws on the bottom of the computer.
Back to Contents Page
1 M2.5 x 5-mm screws (4)
1 touch pad connector 2 tab
CAUTION:
Before you begin the following procedure, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
Содержание Latitude D530
Страница 11: ...2 Tighten the six captive screws labeled 1 through 6 in consecutive order Back to Contents Page ...
Страница 16: ...2 Replace the support bracket and replace the M2 x 4 mm screw Back to Contents Page ...
Страница 30: ...Back to Contents Page ...
Страница 44: ...2 Replace the M2 5 x 5 mm screw that secures the speaker assembly in place Back to Contents Page ...
