Installing system board
1
Align the system board with the screw holders on the computer.
2
Replace the M2.0 x 3.0 screws to secure the system board to the computer.
3
Place the USB Type-C bracket on the Type-C module.
4
Replace the M 2.0 x 4L screws to secure the USB Type-C bracket to the Type-C module.
5
Route the antenna cable through the routing clips and affix the tapes to secure the antenna cables.
6
Connect the power board and the speaker cable to the system board.
7
Affix the coin cell battery on the speaker cable.
8
Connect the USH board, Touchpad board and LED board cables to the system board.
1
NOTE:
If your computer has a WWAN card, then SIM card tray installation is a requirement.
9
Install the:
a
Connect the following cables from the system board
1
LED board cable
2
USH cable
3
Touchpad cable
NOTE:
To reconnect the IR camera, touchscreen, eDP, and G-sensor cables, refer
.
b
c
d
e
f
Extracción e instalación de componentes
31