Dell Inspiron 530 Series, Руководство пользователя, Страница: 89 / 226

Troubleshooting Tools
89
N O BOOT DEVICE AVAILABLE — No bootable partition on HDD or Not a bootable
floppy in floppy driver, or HDD/Floppy cable loose, or No bootable device exists.
• If the floppy drive is your boot device, ensure that a bootable floppy disk is in
the drive.
• If the hard drive is your boot device, ensure that the cables are connected and
that the drive is installed properly and partitioned as a boot device.
• Enter system setup and ensure that the boot sequence information is correct
(see "Entering System Setup" on page 188).
N O TIMER TICK INTERRUPT — A chip on the system board might be
malfunctioning or motherboard failure (see "Contacting Dell" on page 202 for
assistance).
N
ON
-
SYSTEM DISK OR DISK ERROR
— Replace the floppy disk with one that
has a bootable operating system or remove the floppy disk from drive A and restart
the computer.
N OT A BOOT DISKETTE — Insert a bootable floppy disk and restart your
computer.
U S B OVER CURRENT ERROR — Disconnect the USB device. Use external power
source for the USB device.
N O T I C E - H ARD D RIVE S E L F M O N I T O R I N G S Y S T E M HAS REPORTED THAT
A PARAMETER HAS EXCEEDED ITS NORMAL OPERATING RANGE . D ELL
RECOMMENDS THAT YOU BACK UP YOUR DATA REGULARLY . A PARAMETER OUT
OF RANGE MAY OR MAY NOT INDICATE A POTENTIAL HARD DRIVE PROBLEM . —
S.M.A.R.T error, possible HDD failure. This feature can be enabled or disabled in
BIOS setup.
book.book Page 89 Monday, October 6, 2008 11:28 AM