Figure 68. Installing expansion card into the expansion card riser
NOTE:
Push the card holder to hold the full length card in the riser.
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
After working inside your system
.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing the R1 paddle cards
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3. If installed,
4. Remove the paddle card cable from side wall bracket.
5. Disconnect the paddle card cables from the drive backplane.
Steps
Press the blue release tab on the paddle cards and holding the edges lift the paddle cards from the riser connector on the
system board.
82
Installing and removing system components
