Back to Contents Page
Attaching and Removing the Computer Stand
Dell™ Dimension™ 4700C Service Manual
To attach the stand:
1.
Rotate the computer to an upside-down position.
2.
Insert the screw into the bottom of the stand.
3.
Align the two tabs and the screw on the stand with the tab holes and screw hole in the bottom of the computer.
4.
Tighten the screw.
5.
Place the computer in the upright position.
To remove the stand:
1.
Turn the computer over so that the stand is at the top.
2.
Loosen the screw and lift the stand away.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
NOTE:
Place your computer on a soft surface to prevent scratching the top cover.
Содержание Dimension 4700C
Страница 31: ...3 Place the computer in a horizontal position until you reattach the stand Back to Contents Page ...
Страница 38: ...Power Supply DC Connector Pin Assignments DC Power Connector P1 Pin Number Signal name 18 AWG Wire ...
Страница 40: ...Back to Contents Page Pin Number Signal Name 22 AWG Wire 1 5 VCD Red 2 GND Black 3 GND Black 4 12 VDC Yellow ...
