Dell BigIron RX-16, Руководство по установке

Страница: 115 / 240

BigIron RX Installation Guide 103
53-1001811-01
Configuring IP addresses
4
For example, to assign the IP address 10.0.1.1 to the management interface, do the following:
1. At the opening CLI prompt, enter enable.
BigIron RX> enable
2. Enter the following command at the Privileged EXEC level prompt (for example, BigIron RX#),
then press Enter. This command erases the factory test configuration if still present:
BigIron RX# erase startup-config
CAUTION
Use the erase startup-config command only for new systems. If you enter this command on a
system you have already configured, the command erases the configuration. If you accidentally
erase the configuration on a configured system, enter the write memory command to save the
running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command:
BigIron RX# configure terminal Privileged EXEC Level
BigIron RX(config)# Global CONFIG Level
4. Configure the IP address and mask for the management interface by entering the following
commands:
BigIron RX(config)# interface management 1
BigIron RX(config-if-mgmt-1)# ip address 10.0.1.1 255.255.255.0
Syntax: enable [<password>]
Syntax: configure terminal
Syntax: interface management 1
Syntax: [no] ip address <ip-addr> <ip-mask>
Syntax: or
Syntax: [no] ip address <ip-addr>/<mask-bits>
Assigning an IP address to an interface, virtual Interface,
or loopback
As you have done with other Brocade devices, you must assign an IP address to each interface and
virtual interface over which user packets are routed. You can also assign an IP address to a
loopback interface, which is generally used for testing and diagnostic purposes.
You must use the serial connection to assign the first IP address. For subsequent addresses, you
also can use the CLI through Telnet or the Web management interface. You can use IronView
Network Manager Network Manager to assign IP addresses to virtual routing interfaces only.
By default, you can configure up to 24 IP interfaces on each interface, virtual interface, and
loopback interface.