Dell 5210n Mono Laser Printer, Руководство по обслуживанию

Страница: 178 / 430

3-6
Service Manual
PRINT TESTS
Input source tests
The purpose of the diagnostic Print Tests is to verify that the printer can print on media from each of the installed
input options. The contents of the Print Test Page varies depending on the media installed in the selected input
source.
Check each Test Page from each source to assist in print quality and paper feed problems.
To run the Print Test Page:
1.
Select
PRINT TESTS
from the Diagnostics menu.
2.
Select the media source.
Tray 1
Tray 2 (if installed)
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
Multipurpose Feeder (if installed)
Envelope Feeder (if installed)
3.
Select
Single
or
Continuous
.
•
If
Single
is selected, a single page is printed.
•
If
Continuous
is selected, printing continues until
Stop
( )is pressed to cancel the test.
If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is
selected, the test pattern is printed only on the first envelope.
Note:
The Print Test Page always prints on one side of the paper, regardless of the duplex setting or the
presence of a duplex option.
Press
Back
( ) to return to PRINT TESTS.
Print quality pages (Prt Quality Pgs)
The purpose of this diagnostic function is to allow printing of the print quality test pages with the toner cartridge
lockout function disabled. The print quality pages consist of three pages. Page one contains a mixture of
graphics and text. Pages two and three only contain graphics. If duplex is turned on, the pages are duplexed.
The Print Quality Test pages are printed in English and must always be printed on letter, legal, or A4 paper.
To run the Print Quality Test Pages, select
Prt Quality Pgs
from PRINT TESTS. The message Printing
Quality Test Pages is displayed.
Note:
The print quality test pages can also be printed from the Configuration menu (CONFIG MENU), however
a cartridge must be installed with a machine class ID matching the machine class ID stored in NVRAM.
Additional diagnostic information may be printed on the pages when printing from DIAGNOSTICS.
The following is included in the DIAGNOSTICS version of the print quality pages:
•
Values from EP SETUP in DIAGNOSTICS, including:
Fuser temperature, warm up time, transfer, print contrast, and charge roll settings.
•
Contents of the EVENT LOG from DIAGNOSTICS.
•
Configuration information, including printer serial number, controller code level, engine code level, operator
panel code level, font versions, and cartridge information.
•
Default values for the QUALITY MENU settings used to print the pages.