Dell 3250, Руководство по эксплуатации продукта

Страница: 64 / 240

64
Running the FRUSDR Load Utility
Use the FRUSDR Load Utility to manage the server management subsystem’s product level FRU
and SDR repository. Follow these steps to run the FRUSDR Load Utility:
1. Boot to the EFI Shell. For information on how to boot the server, refer to Booting from the
Service Partition.
2. Copy the FRUSDR package to a removable media or to the hard drive. You will find the
FRUSDR package on the CD-ROM that shipped with the server.
3. Load the IPMI driver by typing
load ipmi.efi
NOTE
The IPMI driver file name may change independently of the FRUSDR Load
Utility.
4. Run the utility by entering a frusdr command based on the following syntax:
frusdr
[option] [/p]
The frusdr command accepts single options only. You can accompany any option with the /p
switch to cause the output to pause between blocks of displayed output. For descriptions of the
FRUSDR Load Utility command-line options, see FRUSDR Load Utility Command-line
Options.
5. After using the utility, reboot the system by powering off the server and then powering it back
on. The reboot operation is necessary to reload the firmware and initialize the sensors.
FRUSDR Load Utility Command-line Options
The basic command-line format is:
frusdr [/?] [/h] [/p] [/d { fru, sdr}] [/Cfg filename.cfg]
Where:
/? or /H
Displays usage information
/D SDR
Displays the sensor data records
/D FRU
(Address)
Displays the FRU located at a given address, allowing any FRU to be displayed.
When the utility is invoked with the
/D FRU
or
/D SDR
command-line argument, the
indicated area is displayed. If the given display function fails because of an inability
to parse the data present or hardware failure the utility displays an error message.
The parameters following
/D FRU
are:
NVS_TYPE
DEVICE_ID
DEV_CNTR
NVS_LUN
DEV_BUS
DEV_ADDRESS