Figure 63. Installing the primary drive bay assembly
Next steps
1. Reconnect all the disconnected cables to the backplane.
2. Follow the procedure listed in
After working inside your system
Removing the second drive bay assembly
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
4. Disconnect cables from the interposer, primary backplane 1, and PIB.
NOTE:
Observe the routing of the cable as you remove it from the system.
5. Remove the slimline cable from the riser backplane.
Steps
1. Loosen the one blue thumb screw located at the front of the assembly, and two blue thumb screws located at the rear of the
assembly.
2. Hold the touch points, and lift the expansion card riser from the riser connector on the system board.
Installing and removing system components
87
