Dell EMC PowerEdge XE2420, Инструкция по установке и обслуживанию, Страница: 111 / 173

2. Follow the procedure listed in the Before working inside your system .
3. If removed, install the GPU into the GPU riser .
4. If removed, install the network daughter card .
5. If removed, install the interposer.
6. If removed, install GPU riser 1 or second drive bay assembly .
Steps
1. Holding the edges or the touch points, align the holes on the GPU riser bracket with the guides on the chassis.
2. Lower the GPU riser bracket into place and press the touch points until the expansion card riser connector is fully seated on the
system board connector.
3. Tighten the one blue thumb screw located at the front of the assembly, and two blue thumb screws located at the rear of the
assembly.
4. Re-connect the cables to the power interposer board.
Figure 83. GPU riser 2 installation
Next steps
After working inside the system .
Removing GPU from GPU riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the GPU riser 2 or GPU riser 1.
4. If applicable, disconnect the cables connected to the GPU.
Steps
1. Open the GPU card holder latch.
2. Press the lock on the bottom of the GPU riser, and slide to release the card holder.
3. Hold the GPU, and pull the GPU until the card edge connector disengages from the expansion card connector on the riser.
Installing and removing system components 111